Catcheside JNS colab Gyuto 240mm

$21,948.75 (Inc. VAT)
$17,559.00 (Ex. VAT)
Current Stock:
Adding to cart… The item has been added

One of the kind !

Forged by William Catcheside from Catchesidecutlery and sharpened and polished by JNS 

This cladding is made with many different materials 

Wrought iron which was refined with some carbon steel, Canon iron, plain steel, and a good amount of pure iron, also some pure nickel.

This was twisted and put over a Vintage very low alloy steel c105 from Achim in Germany  

William do mostly forged geometry blades and do not do full ground blades so this one he did only for JNS to sharpen and polish so much more material is used for this one 

 

It got full convex grind with workhorse specs in mind Polished spine and choil, very very nice taper bulky at the handle Shigefusa like and tapers out nicely but not to thin 

Steel is very crispy and super hard I have tested it fully before it made on Website  

It got rare Tamamoku Cedar Handle and JNS Saya included 

 

 

Steel: Vintage c105 Clad with Iron 
Handle: Japanese Tamamoku Cedar Octagonal handle with buffalo horn 

Approx.. measurements:

Handle Length- 145mm
Hell to Tip Length- 240mm
Blade Height at Heel- 53mm
Width of Spine at Handle- 5mm
Width of Spine Above Heel- 4mm
Width of Spine at Middle- 2,5mm
Width of Spine 1cm from the tip- 1mm

wight 240 g 

All knives JNS cary is handmade and made one by one, so they can vary in size and thickness. Unevenness in finish can occur.